HOW DO I HEAT WITH REKORD BRIQUETTES?

Lighting the fire

Lay suitable firelighters, sufficient kindling and a couple of brown coal briquettes on the clean grate. Move the air regulator/slider to the ignition setting or completely open the air inlet. When the fuel has completely ignited, set the air regulator/slider to the desired output level in accordance with the appliance operating instructions, or reduce the supply of air. (An insufficient supply of air leads to smouldering.) Never use unsuitable firelighting aids (e.g. petrol)!

Heating operation

After the phase of lighting the fire, embers are formed. For heating, shake off the ash or rake the embers. Lay a couple of brown coal briquettes on the embers and move the air regulator/slider to the ignition setting or completely open the air inlet. When the fuel has completely ignited, set the air regulator/slider to the desired heat output level.

Keeping the embers warm

Before going to bed, add two to four brown coal briquettes and wait until these start to burn. Then set the air regulator/slider according to the operating instructions. The next morning, after you have shaken off the ash or raked through the embers, place some wood and several brown coal briquettes on top of the embers. Then proceed as described under the heating operation.